Not every missing litre is a problem. Fuel expands and contracts with temperature, and petrol evaporates, so some loss is simple physics. The trouble is that "it's just evaporation" is also the easiest excuse for a loss that isn't. Knowing what normal looks like at your station lets you accept the first and investigate the second.
Temperature: fuel that shrinks after delivery
Fuel changes volume with temperature. Petrol expands or contracts by roughly 0.1% for every 1°C, and diesel slightly less, around 0.08%. Underground tanks stay at a fairly steady temperature, so what matters is the difference between the fuel's temperature when it's delivered and the temperature in your tank.
For example, 20,000 litres of petrol delivered at 32°C that cools to 26°C in the tank:
No fuel has gone anywhere. The same mass now takes up less space. The opposite happens when fuel is delivered cooler than the tank, which shows as a gain. In hot climates, where tankers often arrive warmer than the ground, the effect leans towards loss more often than gain.
Evaporation: petrol's steady leak into the air
Petrol is volatile, so some of it turns to vapour and escapes:
- During deliveries, when incoming fuel pushes vapour out of the tank.
- Through the tank vents, as the tank "breathes" with daily temperature changes.
- At the nozzle, when customers fill their tanks.
Heat, loose or damaged tank caps, faulty vapour recovery equipment and long periods with a nearly empty tank (more space for vapour) all make it worse. Diesel evaporates so little that it should show almost no loss from this cause.
What's normal
These are rules of thumb, not legal allowances. Where your oil company or regulator sets its own permitted loss figures, use those.
| Product | Typical running loss | Investigate if |
|---|---|---|
| Petrol | A few tenths of a percent of litres sold, higher in hot months | It goes above about 0.5% over a month, or keeps climbing |
| Diesel | Close to zero, small gains and losses that cancel out | There's any steady loss, even a small one |
The key word is running. A single day's figure is noisy, because a dip taken a few minutes early or late can swing it. Look at the loss as a percentage of sales over a week or a month.
Physics or problem? Read the pattern
| What you see | Most likely cause |
|---|---|
| Losses on delivery days, smaller in cool weather | Temperature (or a short delivery) |
| Small, steady loss on petrol only, worse in summer | Evaporation |
| The same loss on diesel as on petrol | Not evaporation. Look at meters, leaks or records |
| Loss continues overnight with nothing sold | A leak. Investigate immediately |
| Loss rises in line with sales on one tank | A meter out of calibration |
| Loss tied to particular shifts or staff | Unrecorded sales or theft |
The full list is in our guide to the 7 common causes of fuel loss.
How to keep natural losses low
- Keep tank caps closed, sealed and locked, and replace worn seals.
- Check vapour recovery equipment is working, if your site has it.
- Dip at the same time every day, and never straight after a delivery.
- Schedule deliveries for cooler parts of the day where your supplier allows.
- Avoid running tanks nearly empty for long periods, as far as supply and cash allow.
Set the alarm above normal, not at zero
If every small evaporation loss sets off an alarm, people stop paying attention to alarms. Once you know your normal range, set the threshold just above it. Fuelbotics shows the gain or loss between every dip on the stock loss dashboard, and alerts you when a dip shows a loss or gain larger than it should be, so the real problems don't get lost in the everyday noise.